U1936 BMW Fault Code

Description:

The Throttle Position sensor signals the Engine Control Module as to the current position of the engine throttle valve.
The current throttle valve opening is based on the driver's input from the gas pedal.

The ECM uses the information from this sensor to help calculate fuel delivery and spark timing.

U1936 Code Symptoms :

OBD U1936 code and tailpipe testing are two different approaches to identify vehicles in need of repair. The OBD system looks for broken or malfunctioning emissions control components and U1936, while tailpipe tests sample a vehicle's exhaust to see if it is above or below certain prescribed limits. Given the robust nature of today's emissions control components, it is entirely possible for an individual component to malfunction without leading to an immediate increase in emissions at the tailpipe.

In such cases, other components (like the catalyst) can temporarily compensate for the part that is broken however, these other components can only do double duty for so long before they, too, begin to malfunction. In addition, OBD also monitors for and other malfunctions in the fuel system problems that traditional tailpipe tests were not designed to identify. Most state and local areas also include a gas cap pressure test as part of an emission inspection.

Diagnosis And Repairing U1936

U1936 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to fix U1936 code ?

• Faulty Air Flow Meter
• Faulty Fuel injector
• Fuel tank leaking
• Intake Valve Timing Control Solenoid Valve harness is open or shorted

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code U1936, so consult the manual to locate the brake fluid reservoir.

Bear in mind that a low fluid level can set code U1936 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.